About mhawas

mhawas · 05-15-2019

Hi ,I am deploying a guest SSID at remote location in Felxconenct mode , and trying to do L3 webauthentication but clients are not redirecting to the splash web page. WLC is 3500 model with 8.5.131 software / AP model is 38021.While trying other auth...

mhawas · 01-31-2019

Hi, I have registered the license on new catalyst 9300 model using smart license manager portal. Now it is not possible to connect the switch again to internet or to use proxy methods to send license usage . I am not using any DNA product in my envir...

mhawas · 04-09-2018

Hi all, As i know, to configure HA for 5508 WLCs: "It is mandatory to configure the IP addresses of the Redundancy Management Interface and the Management Interface in the same subnet on both the primary and secondary controllers." i did that , but...

mhawas · 10-04-2013

Hi,I have a situation where number of ie3000 switches are connected in ring topology and i want to add a spoke switch with a fiber link in trunk mode .lets say switch A has IEM-3000-8FM= module and one of the ports (lets say f2/1) on this module will...

mhawas · 05-23-2013

Hi,I would like to know if i can replace traditional ring infrastructutre (IE3000 switch with fiber connection in ring topology) with cisco PON solution.My scenario is a MAN where broadcast traffic (comming from devices to ie3000 access switches) mus...

mhawas · 11-27-2019

As mentioned in the document , you will have to connect to CSSM by configuring this URL on the switchhttps://tools.cisco.com/its/service/oddce/services/DDCEServiceYes, you can ping the domain to test conenctivityping tools.cisco.comPinging tools.cisc...

mhawas · 11-26-2019

Hi,You just have to allow HTTP/HTTPS on the firewall for a L3 interface on the switch to be able to get internet access and communicate with cisco smart portal. You should also have an account on cisco smart portal, and switch license should be place...

mhawas · 07-12-2019

Thanks Georg for quick response ! I would like to use IP SLA to track static routes (HA), from documentation I see that 2960XR supports only IP SLA responder mode. Is there any other way to achieve object tracking on 2960XR (15.2(4)E8) ? regards

mhawas · 07-12-2019

Hi ,Could you resolve this issue? i have the same. regards

mhawas · 05-21-2019

Thanks Patoberli and Ravindran for reply !virtual interface address is 2.2.2.2 and I don't use ant ACL with Flexconenct.It works now , the problem was there was an old unmanaged AP (SOHO) broadcasting same SSID.

Member Since	‎05-18-2013 04:04 AM
Date Last Visited	‎10-31-2023 02:37 AM
Posts	20
Total Helpful Votes Received	5

User Statistics

User Activity

Flexconenct with Web Authentication WLC3500

Smart license cat9k

HA for 5508 controllers with different management subnets

IE3000 and IEM-3000-8FM= configuration

DWDM Ring topoplogy

Re: Smart license cat9k

Re: Smart license cat9k

Re: Sorry about the delay in

Re: Sorry about the delay in

Re: Flexconenct with Web Authentication WLC3500