Hi, I have few AIPs currently under SmartNet services , few AIPs are giving yellow alerts of lic expiration as seen in attached info, we just renew today service contract , the question is would the current lic on these automatically update wi...
Hi, question , Im sure in the past folks have saved threads as references, some threads that may have been impotant to them may have either been saved in their notes or just saved as links , with the new Netpro these links no longer exits, someti...
The board looks nice but not quite suitable for a technical board, this looks like dating board now.I come here to read technical threads not pics , Im sorry to be direct but frankly the previous Netpro site was easy to navigate and straight to the ...
Would like to learn from you what tools I could use in a Network that provides IPv6 visibility and also completely blocks IPv6 from being tunneled through ipv4 only networks.Scenario: I have tested this from Linux running some internal penetration t...
Hi, Have a 2811 router with VWIC-2MFT-G70 along with e1 issue.. two e1s bundled were fine for a while, then one e1 kept having lots of line code violations and stay hard down inactive, provider kept telling me all is fine from smart jack to provider...
There are few scenarios where you want to use route-lookup , go through these notes below - see under "Configuring Identity NAT " purpose notes " Determining the Egress Interface" section , it explains it all https://www.cisco.com/c/en/us/td/docs/s...
Hello there , It seems as though your lab setup could have a flaw , would you be able to share your physical cross connects lab diagram as well as your logical diagram vlans etc.. ? there could be many reasons your servers did not communicate correc...
For this to work you will need to enable same security level intra interface feature on you hub firewall by using the command "same-security-traffic permit intra-interface", you will also need to work on updating your encryption domain access list in...
You are missing the <source> statemente.g nat (dmz,outside) source static webserver-external-ip service tcp www wwwTry the above and see how that worksyou can always place a question mark to provide addition options(config)# nat (dmz,outside) ?<1-2...