About Erik Boon

Erik Boon · 03-23-2015

Hi,I want to configure MQC and bind the policy map to a interface configured as trunk. A few vlan's are configured. 2 of them are used as transit vlan for routing and carries the bulk of the traffic I want to shape. I was wondering how I should "cap...

Erik Boon · 06-27-2014

Hello All,I want to configure VRF-lite and using EIGRP as routing protocol. It's going to be implemented on an existing configuration whereas EIGRP is configured in the global IP routing. What is the best practice of implementing this? Can I configur...

Erik Boon · 04-15-2013

Hello all,I've got a problem of which I hope someone can help me. In our datacenter we've implemented HSRP on 2 6500's for redundancy purposes. Both switches are connected via a trunk. When an interface is administratively brought up, HSRP becomes in...

Erik Boon · 10-30-2012

Hi All,I'm configuring EoMPLS in our LAN and ran into the mtu size. Best practice says to change the mtu size to 1504 (end tot end) due to the MPLS label. The physical link is a trunk and routing is done by OSPF trough a transit vlan. Should I change...

Erik Boon · 04-13-2012

Hi,It might be a simple question but I couldn't find it. Is it possible to adjust the In-Use Connection Timeout for a particular domain (via CLI) and not global as this is the only option I found? We experiencing timeout issues for a particular domai...

Erik Boon · 03-24-2015

Anyone who can help?

Erik Boon · 07-01-2014

Hi,I meant the second scenario. Thanks for completing the answer.Gr,Erik

Erik Boon · 07-01-2014

Thanks Reza!I agree I should do this during a maintenance window, but are you sure adding above configuration wil cause een outage in the global routing instance. I tried it in a lab and it didn't.Erik

Erik Boon · 04-16-2013

Hi Inayath,Thanks for your great response!Looking at the CPU, the utilization is 7% and 20% at peak moments. Although I'm not 100% sure as the shortest time range to check the CPU utilization is 1 minute average. The flapping happens in a few seconds...

Erik Boon · 04-16-2013

Hi pdriver,Below the output for 1standby group/interface. The timers are default.Switch 1Vlan32 - Group 32 State is Standby 833 state changes, last state change 6d21h Virtual IP address is 172.16.1.1 Active virtual MAC address is 0000.0c07.ac2...

Member Since	‎02-23-2012 05:14 AM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	14

User Statistics

User Activity

Policy map trunk

VRF-lite and existing EIGRP process

HSRP is instable

EoMPLS MTU size

Connection time-out

Anyone who can help?

Hi,I meant the second

Thanks Reza!I agree I should

HSRP is instable

HSRP is instable