About michael.lussier

michael.lussier · 02-18-2014

It seems that I have a problerm with AP's connecting to the 5508 controllers. I use infoblox as my DHCP servers. I use option 43 my string is as follows. 0xF10C0A09F5050A09F5060A0CF505I have the primary/ Seconday and teriary controller listed.The que...

michael.lussier · 10-25-2013

Hello all, I have multiple remote office locations and I have implemented HREAP using central authentication and local switching. The offices have 3 vlans. switch/router mngmnt, Wireless management and the office vlan. The access points are 3502I. Th...

michael.lussier · 10-11-2011

I have an interesting problem. My connections to the guest wired access drop consistanly every 1 -2 minutes. There are no drops in the mobility between the WiSM and the 4402 anchor in the DMZ. DHCp is served from the 4402 DMZ controller as well as t...

michael.lussier · 09-01-2011

Good monrng all.I have seen this not once but now twice in less than a week. I have several remote offices up on HREAP. The configs were done on the WiSM using 7.0.116.0 code. the configs were saved and the sup720 in the 6500 was upgraded and reboo...

michael.lussier · 07-21-2011

Good morning to all, I have finished the preliminary work in our lab and I think I'm ready to deploy. However a coworker brought up an interesting point that I couldn't answer. I'm creating a small /29 scope on the state office router 192.168.1.0/29 ...

michael.lussier · 02-18-2014

From what I had read it had to be 0C. I wanted to be sure. I did test with both 12 and 0C and neither seemed to work. With that said, is option 60 have to be used in the newer code or is that still optional or a requirement ? The way I read it in on...

michael.lussier · 10-25-2013

All traffic internet included comes back to the main office.

michael.lussier · 03-28-2012

Shawn, I went back and reviewed everything and everything was duplicated , Except... WLAN_ID. The Wlan ID tags were different. I created a test and failled my two test AP's and they both came up on the backup controller with the proper vlan ID. now I...

michael.lussier · 03-28-2012

My setup is very similar to this. I'm running ver 7.0.230.0 code. I have the same problem. I loose the office vlan's on a failover from the primary to backup controller and gain in the other direction.

michael.lussier · 09-06-2011

I'm using local switching for the remote office users. Office Switch port config AP Port:! interface FastEthernet0/1 description HREAP Access-Point switchport trunk encapsulation dot1q switchport trunk native vlan 798 switchport trunk allowe...

Member Since	‎09-07-2007 02:14 AM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	91

User Statistics

User Activity

Option 43 question 3500 AP and 5508 controllers

HREAP behavior

Guest-wired access connections drop every 1- 2 minutes

HREAP changing vlan numbers

HREAP Question about state office deployment

Option 43 question 3500 AP and 5508 controllers

HREAP behavior

H-REAP LWAPs losing VLAN mapping when fail to secondary WLC's

H-REAP LWAPs losing VLAN mapping when fail to secondary WLC's

HREAP changing vlan numbers