About ASD VNOC

ASD VNOC · 07-12-2017

1. The Touchpad gets hanged and we need to disconnect and reconnect it again post it starts working. 2. We lose the camera control also and needed to unplug and plug the tablet to regain control.

ASD VNOC · 06-29-2017

All, Whenever I make a TPS calll to this endpoint, I get below. 2017-06-29T13:44:01.317+00:00 VOL-NEW-DELHI eventlog[1701]: RAS SCI: priv->currentLocalAddr: 121.240.218.462017-06-29T13:44:01.403+00:00 VOL-NEW-DELHI appl[1701]: 333.87 H323Call I: h32...

ASD VNOC · 06-18-2017

Hi Folks, I am unable to get this registered. Error: On Endpoint Status Failed: Unable to connect to 115.114.235.86:5060 Proxy 115.114.235.86 URI 4210376403958@115.114.235.86 On CUCM: Unknown Here are the Logs.. 2017-06-18T12:58:59.858+02:00 JLR...

ASD VNOC · 10-14-2020

Is there any way to setup external masks to the extensions on SIP IP phone which are registered on VG during SIP SRST scenario

ASD VNOC · 07-08-2017

The issue was, Whenever MX800 devices gets boot up it sets DoNotDisturb as default conference control, In this case, even if we change it to ‘Allow’ still it does not reflect and DoNotDisturb keeps active. The Work around is, every time a devic...

ASD VNOC · 06-26-2017

Yes, you were correct. There was Routing issue. CUCM IP was not advertised in the VPRN/VRF of PE Router of the device. Thanks -Vaibhav-

ASD VNOC · 04-02-2012

Hi Marcus,I'm also planning to export phones from 4.1.3 and import it in to 8.6 using BAT. Have you completed it? Could you please help me to get the step by step process for the same. Many thanks.

Member Since	‎01-21-2010 02:01 AM
Date Last Visited	‎04-17-2024 12:04 AM
Posts	8

User Statistics

User Activity

IX5000 Issues after restart.

Unable to Make Bridge calls to MX800 Speaker Track... Error : Call Busy cause code: '17:71'

Cisco TelePresence MX 800 not getting registered on CUCM

Re: External Number Mask on SIP SRST

The issue was,

Yes, you were correct.

Upgrade from CCM 4.1(3) to CUCM 8.5