Hi We need to access some of the servers of our busineess partner so I am trying to establish a VPN between our Netscreen Firewall and the partner ASA. Attached are configs and scenario for both. It's failing at Phase 1 . From netscreen side we are N...
Hi ,We are upgrading our Network Infrastructre and I need your comments and help about the following case:Scenario:Two Links on the Site A Router (Receiving all National routes on 1st link from ISP-A and default route on the second link from ISP B)(...
Hi,We have two internet Edge in Site A and Site B in Active Standby mode. Currently we have one ISP link connected to site A router and another to Site B router. AS path prepending is used to make Link 2 less preferred for incoming traffic. VRRP is a...
Hi!Please find attached diagram. I want to have an opinion that which switch shall I replace the Cisco 2960s with so as to elimintae the need for spanning tree in there but then what would be the design look like between Netscreen and those new sw...
Hi, We are in a process to replace our old end of life switches( mostly Cisco 2950's) with some new offerings from cisco. Attached is our current network diagram. Can you please provide a merit of using Cisco Nexus switches in this design and also wh...
Hi,My question is why do I need few thousand routes present in the routing table anyway? to get default routes from the provider on all links and just PBR with an access list of 200 or so prefixes of my country won't do? As per Cisco Website, for on...
PFR is a new thing to me. I was just wondering why can't I do thge normal PBR and apply a route map on inside router interface allowing all of my country prefexes and setting default interface to 1st link. ?
