Has anyone seen a power supply alarm like this before on a 4506 ? >>Problem Description: SYSLOG:C4K_IOSMODPORTMAN-4-POWERSUPPLY - [switchename]- BAD: Power supply 2 has failed or been turned off 2nd question - where is the log output interpreter on...
I have an ASR 1000 that is handling a lot of NAT translations. Our customer is curious to know if we can enable MIB captures via syslog for NAT functions. I can't seem to enter the image name properly in the MIB Locator. Can someone give some hel...
I have several diff 3845's that have the NVI0 int showing different IP address assignments. I have one that show's UNASSIGNED and NO in the OK? column of sh int brief output. These routers all have the ISE NAM module in them. The IPs on most are ...
This is not typical behavior is it ? I can't remember clearing the log with a clear counters. Router is a >>CISCO3925-CHASSIS (revision 1.1) with C3900-SPE100/K9System image file is "flash:c3900-universalk9-mz.SPA.150-1.M4.bin"I did a : clear cou...
I cannot find ANYWHERE a visio stencil for this card. I can all the other POS PA's on the TAC website, but nOT for this PA..does anyone have a link to this PA ??
Hi, no all the lights are green on both supplies and no alarm lit. I could pull the power supply but would need a customer change control to do that. The alarm is coming every 6 minutes. Thanks for the tip on cli analyzer... thx.
To go to TAC I hafta open a SR..which means I gotta go into the data center, get a s/n off one of the 7206's, open the SR, etc. I just modified the 1 port OC3 SM stencil...it works for my objective. IS there an 'attach' feature here ? I'd attach t...
thanks, yes, i have the others. I will try two tacts: create a low priority TAC case to get this from Cisco (if the stencil exists)...or just do Visio magic and just create the other two Tx and Rx ports on the existing one...thx.
thanks, we'll do that then. seemed like you'd need two people to reboot a router...one to execute 'reload' and another to toggle the switch. odd. thx again.
i did that and it DOES show on the router output when looking at the config...maybe its because of my auth level ? I may just let this be, too many other more important things to do than worry about it. thx all the same for the quick responses guy....
