I'm running CUCM 11.0.2 and CUACA 11.0.1.
Under queue management I have set a device with an extension for the 'no operator' condition. But when I call the queue main number and the operator is not logged in I just hear ringing and the call never go...
I'm trying to configure fax detection on a CUBE 4331 version 15.4(3)S4. I have a SIP trunk to the provider and a SIP trunk to CUCM.
I have configured a dspfarm profile transcode with the associate app CUBE. As well as added detect-fax mode local t...
I have an IMP 9.1.1 server configured with CUCM 9.1. Everything seems to be good except that the line status always shows as unknown. Everything is in one presence group. Has anyone seen this? My CUCM gateway on the IMP server is pointing to the ...
Has anyone tried to upgrade the RAM on 7825-H3 server to 8GB while running CUCM 6.1(5)?It boots fine with 4GB but I get a hardware error when I try booting with 8GB. Is there a trick to using both the A and B memory banks? The BIOS recognizes the 8...
It fails at the point of trying to run the VXML app. Produces an error message saying it can't find the or read the file.
I'm trying to get a good answer on whether or not this is supported on the 4331 router platform. And what hardware it is actua...
That makes sense. I changed it to add the # in the vxml file and redid the service fax under application so it read the file again, but I still get the same application fax in dial peer 501 not found error when I place a call in.
In the file now is ...
I'm finally getting back to this. I think I'm close but I get this error when I put a call inbound.
*Dec 2 20:37:22.668: %CALL_CONTROL-6-APP_NOT_FOUND: Application fax in dial-peer 501 not found. Handing callid 131830 to the alternate app
When ...
My setup is
No operator >> device 79003
In CUCM 79003 is a route pattern that goes to Unity Connection for the main auto attendant.
But when there is no operator and I call the main queue number it just rolls to one of the CTI ports and rings. It...
