Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 routers (A & B) sharing a neighbor relationship. If I set the bandwidth for the ethernet interface on router A to a value of '1', to modify the default route advertised to the B router, I still see a value of 1544 on the advertised router t...
Trying to setup VACL to output data on multiple VLANs to one capture port. I have 3 VLANs as part of my security ACL, and have a FreeBSD box off of that trunked capture port trunking all 3 of those VLANs. The access-list for the security ACL is 'pe...
I am seeing alot of these messages in my router:%HW_VPN-1-HPRXERR: Hardware VPN0/2: Packet Encryption/Decryption error, status=4609I am using a VPN encryption module, and this is a 2651XM router. What does this mean, as searches for this exact erro...
Switches running the LAN base feature set support only 255 VLANs, not 1024 VLANs as shown in all templates.http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/15-0_1_se/configuration/guide/3750xcg/swsdm.html
I'm assuming 'switchport port-fast maximum 7' is a mistype? Because that command doesn't exist, and could be your problem if you tried to enter it.If it is, what does the output of 'show port-security interface ' give you, as far as Maximum MAC Addr...
Granted, it shouldn't matter, but your logs are barking about it. In a normal HSRP state, those messages are not seen. So, either there's a configuration issue somewhere, or perhaps some other condition that has not been revealed to this forum....o...
