This VG is connected with CUCM via MGCP. On the CM, GW has been registered.I don't think I can get the inbound correctly. Any suggestion with below configure: interface BRI0/1/0no ip addressisdn switch-type nttisdn point-to-point-setupisdn incoming-v...
Dear all, Currently when waiting is more than 1, cell turns to Yellow. How do we change the increase the value to 2 then change to Yellow status?Kindly suggest and share your knowlege. Regards,James
Before the migration kick off. I would take the DRS backup at the existing regional CUCM.Obviously, I have to make consolidation and customize when import to new CUCM cluster. My question is what are the key files that I need to bulk to the new CUCM ...
My translation rules are simple. voice translation-rule 1rule 1 /^34575243/ /2010/!voice translation-rule 2rule 1 /^2010/ /0334575243/ ++++++++++++++++++++Here are my dial peer and dial pots configure for your ref:dial-peer voice 2 voipdestination-pa...
Hi, I was told that MGCP GW in CUCM will not be support with NTT for BRI connection... Therefore, I have changed the MGCP to SIP trunk. Currently is full service. I have run some debug on isdn q931, voip ccapi inout. Basically, from my cell phone, I ...
Thank you for your reply.Are you sure you don't need dial peer configure in the VG? Now, I am testing remotely, I will visit our LAB and find out if the incoming call really get through.My questions is my configuration parameter is configured correct...
