d-fillmore

d-fillmore · 06-01-2022

In the diagram, R1 and R2 will run BGP with each CPE over a common VLAN/subnet. From the 9Ks, th...

d-fillmore · 05-31-2022

A router connected into a pair of 9Ks w/routed sub interfaces on a port channel. WAN circuits and ro...

d-fillmore · 05-31-2022

Hi, If migrating from a design where a load of WAN circuits terminate directly on a router to one wh...

d-fillmore · 06-08-2020

Thanks!

d-fillmore · 06-05-2020

Hi, I'm want to use the 'genie diff' feature to compare the routing tables of multiple devices betwe...

d-fillmore · 03-24-2020

Thanks, I guess the most important question is, If I set the SVI MTU to 9000, and want to form an OS...

d-fillmore · 03-24-2020

For L2 yes, but is different MTU for L3 SVIs supported?

d-fillmore · 03-24-2020

Hi, I need to change the System MTU on a 3850 to the maximum value - 9198. I will have a client faci...

d-fillmore · 12-22-2017

Thanks for this post, it's really helped me out. A problem I have found with it is, that it only see...

d-fillmore · 11-04-2016

Thanks Nick, unfortunately the device under my control does not have the advanced networking license...

d-fillmore · 10-27-2016

Hi - Yes you should configure 'spanning-tree port-type edge trunk' on trunk ports connected to a UCS...

d-fillmore · 10-27-2016

Hi Aslam, To answer question 1, this depends on what the default config on your IBM blade switches i...

d-fillmore · 10-27-2016

Hi LJ, Thanks for your reply, but the trustpoint command is not available in NX-OS. I raised this wi...

d-fillmore · 10-03-2016

Hi, I have 22 Nexus 9Ks that I've just upgraded to 7.0(3)I4 so I can use the REST API. I'm using vRe...

d-fillmore · 05-19-2016

Am just posting this here as I found some different symptoms that were fixed by the workaround for t...

Date Registered	‎02-10-2003 07:03 AM
Date Last Visited	‎06-14-2022 07:45 AM
Total Messages Posted	218
Total Helpful Votes Received	24

Re: Options for fast peer failure detection with vPC and orphan ports