OK, now these 2 AP are working with or without the 2x-mode. They are probably failed and unstable and the HP switch are less sensible to their hardware failure then the csico switch? Anyway, I will open a case at Aruba for a RMA on those AP.thanks g...
yes I got the same problem when connecting the AP directly in the switch port and any port.Here is the port config (same on all port, except the 2x-mode that others identicals AP dont need :S) description AP-ARUBA switchport access vlan 204 switchpor...
IOS of my switch is: Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 12.2(55)SE5, RELEASE SOFTWARE (fc1)Here is some tests I had just done:I replace 1 fail AP with a new one and it work just fine (like 40 others without the"power ...
Here is the output:TDR test last run on: February 27 23:06:23Interface Speed Local pair Pair length Remote pair Pair status--------- ----- ---------- ------------------ ----------- ---------------Gi1/0/19 auto Pair A 91 +/- 0 meters N...
Hi, We are at the begining of a wireless deployment in an hospital here, and at this time I have 2 Aruba AP105 that stop working this week with this error log:%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/19: Power Controll...