Yes, it is possible for a Host to act as Source and Receiver and the router / Layer 3 switch is not configured for PIM BIDIR but for PIM ASM (aka Sparse mode). In that case the device is acting as First-Hop Router (FHR) and Last-Hop Router (LHR).
W...
Yes, it is possible to import ipv4 Unicast prefixes into the ipv4
Multicast address family.
Howeever, this can only be done by using the "neighbor translate-update ipv4 multicast"
command. In the following configuration, routes received from
172.16.0...
Wei Jin,These messages are generated by BGP as it processes updates - IPv4 and VPNv4. You may want to check the settings for logs and also if you have any debugs running.For example:- sh run | i log - sh debugLet us know the outcome.
Yuriy,In addition to these commands, you should review the MPLS Label (Outer Label) assigned by the MPLS network to the Xconnect to determine if it is using LDP or if is using a TE-Tunnel, MLS CEF (on the 7600) and the output of debug commands for ...
