About Darren Candlish

Darren Candlish · 06-15-2021

Good Day All Would anybody know which version I would've to patch or upgrade to on Cisco ISE that supports VMware tools version 11,301 or 11.1.5I can't seem to find any matrix, release notes on what version will be required.The Cisco ISE version that...

Darren Candlish · 11-05-2019

Hi All,I am testing SNMPv3 before I roll out across a production network.I am using Cisco DNA to push the configuration out to the seed device.The software we use to monitor the devices are PRTG and is working fine with the seed device.Everything app...

Darren Candlish · 06-01-2013

Hello Everyone, My devices are; L3 3550, L2 2550, three routers and two end devices. I would like to setup HRSP with the L3 switch, routers and end devices but muddled up with the config. I have dhcp addresses to my end devices through the L3 vlan 10...

Darren Candlish · 04-16-2013

Hey AllI am trying to connect my three routers in the same subnet for my ospf studies through a layer 2 switch. First off would this sort of scenario work. I've checked the ip addresses, interfaces, network statements but not getting a ospf adjaency ...

Darren Candlish · 04-03-2012

Hi All,I've a home lab which consists of three 2610xm routers and I have configured two routers back to back with FR subinterfaces. The commands are used are;R1frame relay switchingint s0/0encap FRno shclock rate 64000frame-relay intf-type dceint s0/...

Darren Candlish · 06-16-2021

Thanks Marcelo I will update ISE to the latest version.

Darren Candlish · 04-16-2013

Hi I am unable to paste my configs, it doesn't allow me. It seemed it worked all along, but I didnt check debug which elected the routers and able to ping no problems. Just out of curiosity would routers connect to a switch in production for a multia...

Darren Candlish · 04-16-2013

HiI changed the switch ports to desirable from access and now able to ping devices, but not getting past init for ospf. I changed the routing protocol to eigrp and adjeancy comes up. If it's a shared connection in the same subnet then I wouldn't expe...

Darren Candlish · 04-12-2012

Hi Peter,Thank you for answering my question. I configured the multipoint configuration as I suggested and funny enough the FR worked with the same dlci number. I got lmi through and the data link layer seemed to be working fine, but I couldn't ping ...

Member Since	‎04-02-2012 04:56 PM
Date Last Visited	‎06-16-2021 12:42 AM
Posts	9

User Statistics

User Activity

Cisco ISE VMware Tools

SNMPv3

HRSP over L3 switch & Routers

Ospf

Frame Relay inverse arp

Re: Cisco ISE VMware Tools

Ospf

Ospf

Frame Relay inverse arp