Hi , I was wondering whether we can monitor a Vlan and and RSPAN vlan in a single SPAN seesion with single destination port ? something like this monitor session 1 source vlan 120monitor session 1 source remote vlan 901 (This is the RSPAN vlan carryi...
Hi All,I am trying to understand cisco QoS techniques. I came to know that queueing techniques is used(or comes alive) only when you experience conjestion on your network. Here I am a little confused with a few scenarios in front of me. I am trying t...
Hi All,I am trying to Disable Telnet and enable SSH in Cat Os for 6500 . Can some one help with a step by step instruction ? I have been searching for a while but did not get a convincing answer yet. Please help.Thanks,
Hi All,Finally It worked. Below is the config I applied.To Enable SSH=======set ip permit enable sshset ip permit 10.0.0.0 255.0.0.0 sshTo Disable Telnet===========Set ip permit enable telnetThanks Inayath and all for all your help.
Hi Inayath,Sure . I will give a try today. But when I tried this yestrday set ip permit 0.0.0.0 0.0.0.0 ssh -> It gave me a bad mask error.So not sure it will help. Also it gives a potential vulnerability for snmp since it opens for every one othe...
Hi Inayath,It woked. But I needed to put a filter for a subnet. Here I am required to allow every one .I tried set ip permit 0.0.0.0 0.0.0.0 ssh -> but it did not take that command. Do you know how to permit every one ?
Hi Inayathulla,Thanks for the quick reply. Do we need a permit list to restircit access to certain subnet ? Is that Mandatory?Example : sec-cat6000> set ip permit 172.18.124.0 255.255.255.0 ..Becoz I dont want to put any filter any subnet for SSH. ...
