- Select your UCS Service Profiles that want to add VLAN in SP_Selector Input:- Change Loop_Count to proper number of loops- Select VLAN to add in Service ProfilesEnjoy!
Hi
i have 2 wlc that are configured in HA. after HA setup, HTTPS is not working and only HTTP is working correctly.
i've done these things:
1- regenerate Certificate
2- Disabling and Enabling HTTPS
3- Upgrade software to 8.2 last released
but prob...
Hi everyone
in my ACI environment, there is an issue in implementing Service Graphs in tenants. one off my leaves encounter error in forming a contract. the error is :
"hardware programing failed"
and in system faults , there is a fault like bel...
Hi everyone
in my ACI environment, there is an issue in implementing Service Graphs in tenants. one off my leaves encounter error in forming a contract. the error is :
"hardware programing failed"
and in system faults , there is a fault like bel...
Hari,
I think we can describe difference between NSR and NSF as below:
NSR is for control plane and NSF is for data plane. wherever you need forwarding you should choose NSF and wherever you need Routing convergence , you should choose NSR.
Hi Luis
as may you know, in nexus 1000v , if your deployment mode is L2, then VEM must be in same vlan of Control Link , but in L3 mode, if Control Link can ping VEM, then VEM module comes Online.
Regards