Hello, I am working with a group of engineers who have decided that terminating BGP to our core switch is better than re-distributing into OSPF at the edge. The reason behind this is that it would be easier to have BGP run through our Palo Alto fire...
Hello,I have an issue where users at a site are trying to place outbound calls to the PSTN but are unable to. They receive a dial tone and dial the numbers but receive nothing but silence after dialing the number. Even after 2 minutes there is stil...
Hello, My question is in regards to the recommended hardware specifications for installing RTMT. I know that each CUCM cluster I have requires its own installation of RTMT and that Unity is also a seperate installation. Cisco is recommending that y...
Hello, I am receiving complaints that people outside the U.S. are dialing our number and are then prompted with a second dial tone. They then re-dial the number and it will ring through to our phones. My question is where is this secondary dial ton...
Hello,I am having a problem with my failover design. I have a remote site with an MPLS connection with BGP between the PE and CE routers. On the remote site I am running HSRP between the two routers, however there is no direct connection be...
Problem has been resolved. The solution was removing the skinny inspection on the firewall. It is just one command, no skinny inspect. Once we did this a lot of the little problems and the delay were resolved. Having an ASA in between your IP pho...
Ok, an update:After reviewing packet captures further it appears we are dropping traffic somewhere which is causing the retransmits on the phone side. I am not sure where the packet loss is coming from or what is causing the re-transmits. Thoughts?...
Thanks for the response. I ran the packet capture on both sides. I am seeing retransmits on the remote side where the phone resides. On the CUCM side I am seeing lots of unseen acknowledgements. It thought they were just at the beginning of my ca...