I am trying to create this scenario:Unfortunately, I don't have remote-access to collect configurations, but general it goes:VPC domain 1 configured on 7KVPC domain 10 configured on 5KOn 5K-A interf 1/1 goes to 1/1 7K-A, 1/2 goes to 1/2 7K-B.On 5K-B ...

Tried 1, 3 and 7 m Cisco twinax cables, but Brocade is always reporting unsupported SFP. What should be used? Is there any twinax vendor that's is supported by both?Thanks.

Hi,I just looked all ten ports on SUP in slots 5 and 6 and I can see that Ten 5/3, Ten 5/4, Ten 6/3 and Ten 6/4 are inactive. I am not sure why and is there some restriction or should I add to the configuration?Thanks.

After command clear route, all timers just continue, there is not actually clearing the routing table... This is happening on two different boxes: pair of ASA 5520 and one 5505 ASA... I presume it is happening on all others too, but I don't have this...

Hi,here is the thing.I have asa 5505 that should be connected to two core switches on the inside, and two edge sw on the outside.Cores are interconnected.Edge sw are inteconnected.Since ASA 5505 do not support SPT, I guess the only way not to close t...