Hello, we have L2 switched network with MST enabled. Actual number of switches is 29. We plan add new switches into network. Default value of "spanning-tree mst max-hops" is 20, actual our value is 30.I found in documentation maximum value for this p...
Hello, I have problem with MTU via L2TP multihop. Has anyone information what is sequence of operation, when tunnel switching is provided ? (when packet is switched into second tunnel, is compared with MTU before or after L2TP encapsulation) ?Thanks ...
Hello, I want find any information about DHCP snooping feature on navice IOS running C6513.I am not able find this feature in this image. Know anybody, when this feature is planned in native IOS for 6500 switches ?As I found, this is implemented for ...
Hello, I have 7206VXR router with NPE400 processor module.I need place in this router I/O controller GE+E module, PA-2FE-TX and PA-GE module.If I do bandwith calculation, with whatever HW configuration result is, that bus BW is oversubscripted.Questi...
Hello, I have DHCP clients directly behind PIX in VLAN, subinterface on PIX is default gateway for them. On outside interface is configured tunnel to remote location. DHCP server for clients is in remote location. We tried configure DHCP relay on PIX...
Hi,before Firepower 6.2.0 you need to have Realm, which validate username received from ISE and after that there was pushed mapping SGT-IP to FTD device. As you write you are running 6.1 ..After 6.2.0 you don't need realm to validate username to be a...
Hi Tarik, what about the case, that there is OOB virtual-gateway design ? there is no IP segment change after authentication and "health check" finished. How system allocate authentication and data vlan (and appropriate IP segment) based on AD param...
Hi Ivan,could you please give any suggestion about usage cut-through-proxy and DAP with LDAP together ?any function config or any document on web ?link you specified was just about DAP and there is no specified how it is possible join cut-through-pro...
Hi Ashwin,I will not help you with Part Number (probably you should look into price-list .. there are all Part numbers), but just take project move, you can order "trial" license for IPS appliance. You should have account on Cisco page and go to http...
