Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I hope you are great. I have a cu with:LMS 2.6on windowsMy Cu wants to change his LMS instalation from the C: partition to a new partition that he is going to add to the server.The only way I think of doing this is by:1. making a backup2. Unin...
Hi all,I writing this post because I'm doing an IPICS 2.01instalation right now. I put 4 channels, one with a nextel and 3 with motorola radio bases.I have great comunication between the PMC and IP phones to all the channels, but when I enable a VTG ...
Hi all,I'm having the strangest issue. I'm seen how some of my packets are dropping in one interface of the switch, giga 1/46.I did some test with sniffers and pings. I set up a SPAM session to mirror the trafic on 1/46 and made some pings. I'm seein...
Hi all,I hope that everyone is doing great! I have an issue like this:When I do a show ip ospf traffic I see the following under interface Vlan 104:Interface statistics: Interface Vlan104OSPF packets received/sent Invalid Hellos DB-des LS-...
Hi all,I would like to change the busy signal and the busy fast to a recording. So everytime someone call a busy phone o get a busy fast signal he will hear a recoding.is there any way we Can we configure this on CUCM?Thanks a lot for all your help.
Hi Raj,Yes but I'm seeing in the packet capture that the firewall is replying the ping, and I'm seeing that is reaching the SW.Yes if I ping from the Firewall to this switch or from other servers to this switch I see that some ping get lost. This hap...
Thanks For the answer Raj,The 200.38.105.6 it's a firewall. What we are seeing is that some times we see that some packets are missing on the normal traffic. We start to acknowledge this when we start too send some streaming and the streaming start t...
Hi,Thanks for the info, this is great. My only question now is how can I solve this? is My only option To fix this open a case with the Cisco TAC?Thanks a lot for all your help.Ramón
