5Ghz Clients are connecting to faraway AP even if they sit under the same model another 2700i AP. Both AP's are autonomous. Attached configuration files from both AP's. Also need the debug command which will work on autonomous AP.

HMIMUM-SW-WMS#sh versionCisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 15.2(2)E9, RELEASE SOFTWARE (fc4)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2018 by Cisco Systems, Inc.Compiled Sat 08-Sep-18 14:56...

We observed one link between TNCHNPERNER03 to KKBNGBTPNCR02 has flapped at the same time observed route flapped between source to destination. We observed destination Ip is taking path via Po12 but observed less traffic , for now we have shut the Po1...

Cisco Catalyst 9200L-48P-4X Switch rebooted automaticallyLast reload reason: unknown reload cause - reason ptr 0xF, PC 0x0,address 0x0cisco IOS Software [Fuji], Catalyst L3 Switch Software (CAT9K_LITE_IOSXE), Version 16.9.3 ROM: IOS-XE ROMMONBOOTLDR:...

Hi Guys,   Can you please help me to configure the IR829. Since I have no much experience on this devices.   We have the requirement to configure the gateway to make the cellular0 as an access point of internet as we are using a 4G LTE sim, and then ...