Following is how we can retrieve and interpret sensor (power, voltage, current) of a slot/port via SNMPFor example this is the CLI output from 6500 and we want to monitor tx/rx power for Te2/4#sh interface transceiver detailOptical High Al...
Hi John
VLANs on peer-link are going in to inconsistent state because BPDUs are timing out and Bridge Assurance is kicking in. So basically we need to check why BPDU are not receiving intermittently. Please check the below:
- Check if CPU goes high d...
Hi Fhgallardo
As i understand you have two N7K connected directly with FI-A and FI-B. Downstream to which UCS 5108 chassis is connected. Also you have storage array VNX5500 and spectra tape library for backup purpose. I am not sure but these storage ...
Hi
It is an expected behavior. IP SLA probes configured via snmpset will not be seen in 'show run'.
We need to use 'show ip sla conf' to check the configuration.
Thanks
Mahavir
Hi
At first hand it seems a connectivity issue between remote NMS and router.
Have you verified connectivity between remote NMS and router?
Is ping works between them?
If yes then is there snmp ports opened between them..not blocked by some FW etc...