Dear Friends,
I will implement a new UCS project and I have this Part Number C1UCS-OPT-OUT for each Blade Server.
I take a look in the Cisco site but I didn't find any reference to it.
If someone could explain me what is this Part Number is for I w...
Hi, I have a question about the best manner to include a Cisco ASA do a Cisco Prime Infrastructure 2.x Is better to add the Cisco ASA using the principal address only or is recommended to add twice the Cisco ASA using both the principal and stan...
Hi Everyone, If a press the button UDI in the 3850, I can see the Beacon light blue to help the switch identification. How can I turn on this blue led identifier using the command line ? Thanks in Advanced Andre Gustavo Lomonaco
Hi, I have a customer who is running FWSM version 2.3(5).I can see the show running-config all and I see a lot of nat exceptions (nat 0) but I don't find the nat-control command. I have two questions: 01) Someone knows if in the FWSM version 2.3(5) ...
Hi Payal, thanks for your reply.So just to clarify.Do you recommend after update the infrastructure always update the default host firmware pack with this new version to use the Auto-Sung Server Policy ?Thanks a lot for your helpMy Best RegardsAndre ...
Hi guys, thanks for the reply.The WWNP is being derived from a WWPN default pool (unfortunately no sequencial)I'm think about to delete the services profiles (only 8) and recreate the pool as sequencialThanks again for the answers
Hi Payal,My question is about the procedure to update the FI and the serversI usually use the auto install upgrade method to upgrade first the FI (and the UCSM)After I create a Host Firmware with the new firmware and I use it inside the service profi...