I am looking for two new routers to be used to connect to two ISPs for internet connectivity. The basic design requirements are below: - dual, multi-homed BGP design. - 100 Mbps per ISP, so an aggregate of 200 Mbps. - Each router will connect to ...
I have a Cisco WS-C3750X-12S swith with dual C3KX-PWR-350WAC power supplies that are both currently connected to 110V PDUs. We are being forced to migrate over to new 208V PDUs and I would like to know if it is possible to run this switch with one p...
I would like to know if it is possible to remove only the "Go to address" icon from the floating toolbar. This question was asked in the following discussion, but the only answer that was provided was to disable the toolbar entirely. - https://su...
According to the spec sheet in the link below, the 4331 has a native bandwidth capacity of 100 Mbps and the 4431 has 500 Mbps. It also shows the bandwidth of the 800 series routers. Even if the actual bandwidth of the 4431 is half of the reported 5...
Thank you for the replies. I looked up the specs on the 3925E and I also had a quick discussion with a reseller about this and they recommend the ISR 4431 router instead of the 3925E. It is a 1U form-factor with 4 GE interfaces, dual-power supplies...