Recently got two 2960s to replace in service late model 3750s directly connected in remote locations via direct fiber. Have not been able to get the link to stay UP - they flap and go err-disable immediately. If i use the same fiber and connect the 2...
Hi all,I have two uplinks to ISPs on one router in which they give me only default routes via BGP. I'm looking for the best way to load balance acrross both circuits with minimal config.
TAC pointed to a documented bug behavior: CSCvg04687. My solution was to replace on of the new 2960L units with a 11 year old 3750. Basically just subscribe to the bug tracker for CSCvg04687 and wait for a fix in 15.2(6)E2. ¯\_(ツ)_/¯
I've only got access to one site today which is listed below. The remote site is the same, as I've gone through all the steps to show output while screen sharing with support on the phone - SR 683713560Port Name Status Reason...
I have uplinks to two seperate ISPs and receive a only receive a default route from each via BGP. Both links are the same speed and BGP is used only to advertise our prefixes out - nothing hectic. I was thinking the easiest solution would be to add t...