About v0r73x117

v0r73x117 · 01-27-2015

Hi Everyone,Hoping for some advice on a network topology we are looking to deploy, I've attached a quick image of the layout and wanted to confirm it's possible?We're now being offered some redundancy from our ISP where they will provide a HSRP setup...

v0r73x117 · 08-06-2014

Hi All,I have the requirement to set up a VPN from our network to a Developer with the basic topology below:Our Private Subnet -- ASA (WAN IP) -- VPN -- Developer Public Endpoint --- Developer Protected Public IPsSo the developer has a bunch of publi...

v0r73x117 · 06-06-2013

Not sure how to best phrase this question as it's proving difficult to pinpoint the root cause!In brief we have an ASA 5505 device (cleaned config attached) with a 48 port gigabit HP ProCurve v1910. The HP is running the latest firmware available and...

v0r73x117 · 01-03-2013

Hi All,Just looking for comfirmation on what is/isn't possible. In brief we have a site-site requirement but our local LAN ranges conflict. I'm aware of how to get this up and running using a pool of IP's that either an ASA/IOS based device can NAT b...

v0r73x117 · 09-07-2012

Hi All,We currently have the issue as referenced in another older post (https://supportforums.cisco.com/thread/289965) but I'm a little confused as to where/how the workaround for the older CME4.0 version is to work.In brief we have two DN's which we...

v0r73x117 · 01-28-2015

Hi Jon,Thanks again for the insights, linking the firewalls direct to each switch probably does make more sense / simplifies the setup I may have just been over zealous on resilience options :)The interconnect between our two 3560's is the 100Mb chok...

v0r73x117 · 01-28-2015

Hi Jon,Thanks for the response! To answer the queries -1) Yes, the ASA's will perform all our NAT requirements. I'm triple checking with our ISP on their routing so thanks for highlighting.2) ASA wise we have a bunch of sub interfaces for VLANs so we...

v0r73x117 · 08-07-2014

Hi Karthik,Sorry are you saying that example is correct?If we PAT traffic for our VLAN10 out 1.1.1.1 for example, it's this IP that we use as the Peer as it is also the IP that it will see as the interesting traffic to bring up the VPN when destined ...

v0r73x117 · 08-07-2014

Hi Karthik,Thanks for the response, that was my initial understanding so hopefully it's correct.Yes traffic is initiated from LAN users where the other side does have direct public IPs we are accessing. Would there be any further considerations shoul...

v0r73x117 · 06-06-2013

For the clients that drop it appears to be mixed. Sometimes we'll see their IP/MAC when we issue a show arp other times we won't see them at all.One instance we saw the entry for the client, could not ping the client, removed the individual arp entry...

Member Since	‎08-09-2011 08:36 AM
Date Last Visited	‎08-18-2021 12:04 AM
Posts	28

User Statistics

User Activity

HSRP on WAN & LAN Interfaces to ASA HA Pair?

ASA L2L WAN IP to Public Peers

ASA 5505 / HP 1910 ARP Issues

Site-to-Site with Overlapping Subnets

CME 4 Not Ringing Overlay Phones

Hi Jon,Thanks again for the

interface redundant 1 member

Hi Karthik,Sorry are you

Hi Karthik,Thanks for the

ASA 5505 / HP 1910 ARP Issues