Hi,I know Unity Connection is already end of support, but I have a customer still using that version.The security certificate has been expired, my question is how do I regenerate this certificate? Unity conn still works fine except for the media mast...
I am trying to extend an existing CM 4.1.3 implementation with video conferencing. Customer bought an 3527 IP VC, software version 5.1I configured the IP VC in peer-to-peer mode (without GK). The 3527 has been configured as a H.323 gateway in Call Ma...
Hi,Thanks for your feedback, but I am not shure if this something to do with the license, I clearly see that the certificate is (only) valid for 5 years, I always thought that Unity license is permanent.
Philips,I am not sure if resync was stuck or not. After the firmware and first reboot I waited two hours. After that it was still out of sync according to the show hardware command. Then I rebooted again and entered the RAID bios, sync level was stil...
Hi Shane,Thanks for your reply, clear. Do you know what the exersizer is doing, is it checking the disk?Further, After I applied the firmware update, both disks where out of sync. After the reboot I got a message that it was doing a re-sync. However ...
Hi Philip,I have two questions regarding the mentioned procedures.- What are we doing with the cop file, what's in it- Do I have to re-apply the cop file after a upgrade to a new CUCM SU or CUPS build?At the moment I am perfoming the procedure on CUC...
Hi Charles,Although your squence is OK, I still have to make some remarks. I spend a lot of time in solving a RAID issue, after the motherboard has been changed by HP due to a defective on-board RAID controller.Setup was the same as yours, MCS7825-H1...
