Hi configuring Site-2-Site IPSec VPN on IOS routers with IKEv2. On Hub-site i want to configure "responder-only" but do not find where to configure it.I'm using dynamic crypto map feedback very much appreciated here's the config from VPN hub-router I...
Hirunning RV340 with 1.0.03.15 and configured for SSL-VPN; AnyConnect 4.7.04056 (MacOS)When connecting to RV340, AnyConnect client hangs for 75 seconds and is waiting for "Checking for customization updates ..." see stats attached.where and how to sk...
RV340 (1.0.02.16) and SSL VPN
When AnyConnect client does disconnect, sessions on RV340 stay connected for some time.
Later on when AnyConnect client tries to reconnect to RV340 again, session gets rejected because of no licenses available.
On ASA se...
Hi
Is there a possibility to view all dynamic NAT table entries on RV340 ?
Looking for something like "sh ip nat translations" on IOS routers; could not find something similar in WebUI ...
running now on latest 1.0.02.16 firmware.
Have several SVI'...
Hiis there a CLI command to display the SFP model/type inserted in ports ?on ios switches, there are several commands to show this informationi have some SFPH10GB-CU3M and SFP-10G-SR and want to see from remote in what slot they are inserted.regards
Hi Mike
thanks for your input.
I was also thinking about access rules; but did not test it yet.
Do you also have an idea how to see active NAT translations ?
HiThe SFP-H10GB-CU3M and the SFP-10G-SR are supported by the SG500X platform since they are listed under Accessories (Stacking Options and Modules).Would be nice when we could read out this data.regards
