If we restart the Spark kit plus, the Cisco Proximity App connects. Then if we quit the app and launch again it fails to connect. From same laptop model, we can connect successfully to DX80.
Please suggest.
Hi Kristi,Please login to MCU and go to the conference in which endpoints are connected/ are about to join.Please check the minimum outgoing bandwidthRegards,Sagar
Hi Tufan,Yes, with the setup you mentioned any TX endpoint can make point to point call to endpoints registered to VCS (including jabber video) .Regarding adding the CUCM and CTS endpoints to TMS , you can refer the TMS 13.x admin guide.Also CUCM ver...
Hi Saad,A small correction here. CUCM is not a gatekeeper and you cannot register Profile system to CUCM using H323.However You can use SIP to register and call between immersive and profile systems.Hope this helps.Regards,Sagar