I am trying to add conditions (equipment related) to my TACACS Authorization policy and it is there before I save the policy, but when after it is done saving, it disappears and it not there anymore. I edit the rule and the condition is gone.
Have an ASR1006 running IOS-XE 03.04.00.S.151-3.S and trying to change the admin distance of a route in a VRF:router bgp 65525bgp log-neighbor-changesno bgp default ipv4-unicasttimers bgp 15 45neighbor 10.47.129.251 remote-as 1234neighbor 10.47.129.2...
Trying to dial out but continue to get this in the log:2760820 07:34:48.888 H.323 Info New connection accepted from 10.1.1.17 2760821 07:34:48.888 CONNECTION Info Accepting incoming IP to ISDN call 2760822 07:34:48.967 CONNECTION Info...
What I found is that I was trying to use POLICY ELEMENTS>NETWORK CONDITIONS>DEVICE NETWORK CONDITIONS, which from a network person perspective would have made sense, but after some more reading found that I actually had to use POLICY ELEMENTS>CONDITI...
By site to site are u talking DMVPN or just FW to FW.....we ise 7200 G2 as dmvpn hib with older 3800 as spokes. If i were refreshing this it would be an ASR1004 as the hub and 3900 as the spokeSent from Cisco Technical Support iPhone App