About Sally Daugherty

Sally Daugherty · 03-31-2016

I have 8 Catalyst 2960X-24TS-L switches, all configured the same. 4 switches make up one network and 4 switches make up another. I have an Fluke analyzer that I connect to the networks to "see" what's out there. When I connect to the first network I ...

Sally Daugherty · 04-04-2016

I finally found it. There was a setting in the analyzer that was restricting the ip addresses of the network in question. Removed the restriction and now the analyzers "discovers" everything. Thanks to those who responded with suggestions.

Sally Daugherty · 04-01-2016

All the clients have valid IP addresses. The system works fine other than I cannot "see" any devices when I connect the analyzer to the switch to "discover" everything that is connected. I do this to determine if there is something out there that sho...

Sally Daugherty · 04-01-2016

The system we have requires spanning tree be disabled.

Member Since	‎06-07-2013 01:35 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	4

User Statistics

User Activity

Cisco Catalyst 2960X

I finally found it. There was

All the clients have valid IP

The system we have requires