About Matt Smith

Matt Smith · 09-30-2014

Hello,One of my offices SIP trunks requires registration. In single CUBE mode this isn't an issue.I have recently been configuring HSRP for CUBE HA and my registrations are being sourced by the interface IP rather than the HSRP Virtual IP address. In...

Matt Smith · 09-17-2014

Hello,I've been attempting to configure a 2nd cube at our main site with HSRP. Inbound calls (I've only been testing inbound at this point) disconnect after about 15-20 seconds without any DTMF response from the IVR (unity). SIP messages from the ITS...

Matt Smith · 06-19-2014

Hello Unity wizards; I've been following the guide here: http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/connection/9x/srsv/guide/9xcucsrsvx/9xcucsrsv010.htmlSoftware Versions:Cisco Unity Connection version: 9.1.1.10000-32 Cisco Unity Connect...

Matt Smith · 03-19-2014

Hello, I have a translation rule where I'm attempting to replace a called range with a specific number:voice translation-rule 998rule 1 /\(\+4922126103[1-399]\)/ /+49221261030/ This works as expected on a single digit in the range:test voice translat...

Matt Smith · 12-04-2013

I'm using UCM 9.1 with Unified Mobility (xfer to alternate number) with good success if I follow a typical call flow:Inbound call -> Ext -> Rings deskphone x seconds -> Rings mobile phone -> Answer mobile phone -> hangup -> Resume call on desk phone....

Matt Smith · 09-25-2014

I wanted to follow up with the eventual solution if anyone runs into this in a search.The problem (which isn't a problem without HSRP) is that my inbound and outbound dial-peers were combined, each containing a destination-pattern (cucm call leg) and...

Matt Smith · 09-24-2014

Good info, much appreciated.But unfortunately I still can't get this working properly. I applied the sip-profile to dial-peer 10 (inbound call) and was able to modify the contact details in the sip header, and some of the sdp header info as well, but...

Matt Smith · 09-18-2014

I'll run though this once we're out of production.I need some clarity on the interpretation of the 200 OK. The example you posted seems to be the opposite scenario, where the cube isn't responding to the ITSP's 200 OK:ITSP: 173.46.30.202cube external...

Matt Smith · 09-17-2014

For sure; I've attached a couple debug files.I can hear Unity IVR but DTMF is not recognized. Audio drops completely at 14-15 seconds and the call disconnects at 19 seconds.I also notice one of the call legs hangs around for a while after the call is...

Matt Smith · 07-11-2014

Hi Mike thanks for the response.I ended up going with SIP between the CUBE/Unity SRSV as well with dial peers for DID's (higher preference ) and the voicemail extension.I ran into an issue where calls from Unity SRSV to registered ephones were going ...

Member Since	‎05-01-2013 06:53 AM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	35

User Statistics

User Activity

Sourcing SIP-UA registration from HSRP Virtual IP address

cube sip hsrp media negotiation failing

Unity connection SRSV

CUBE translation-rule replace called range with specific number

Unified Mobility, no audio on Send call to Mobile Phone

I wanted to follow up with

Good info, much appreciated

I'll run though this once we

For sure; I've attached a

Hi Mike thanks for the