Hi Is it possible to run Trustsec over a 3rd party VPLS / Telco switching service.Have managed to find options with Macsec for setting authentication to happen in unicast to avoid the transit provider trying to process the eapol messages but cant se...
Hi
So I have a cisco ISR 4331 and have been told the router was supplied with a throughput license to scale the performance to 300mbps
Why does the router have 2 throughput licenses in different stores ?
Is this router correctly licensed for throug...
Hi
I've got a DMVPN running over a MPLS network, running DMVPN phase 2 between all the CE's.
All Hub to Spoke & spoke to spoke is working correctly.
Is there any way to keep all the spoke to spoke tunnels up permanently so that they don't need to...
Hi
I've got a weird issue.
I have a cisco 7200 connecting to a cisco 2901 via a telco providing a layer 2 service and trying to get a 1500 MTU end to end, un-fragmented.
If I configure both ends as a single tagged sub-interface, I can get up to 1...
Hi
Is it possible to use multiple vty access list to control access to the router on different vty instances ?
Example use standard access list 1 to restrict vty 0 4 and use access list 2 to restrict vty 5-6
We have this setup on multiple different ...
platform hardware throughput level 300000 & the reboot has been done.
But the license is showing 2 throughput licenses, one showing permanent & other showing evaluation so confused
I'm using EIGRP over the DMVPN
I've disabled EIGRP split horizon & eigrp next hop self so that the spoke route directly between each other, just concerned that the delay when a spoke to spoke initiates a call may be an issue due to the tunnel initiat...
I'm concerned that there may be issues with voip from a spoke to spoke site as there will be a slight drop when the spoke to spoke tunnel initiates, voice signalling would be from Spoke to a gateway behind the HUB, so spoke to spoke would only initi...
Managed to find the issue, was linked to bug CSCuo71154 on EHWIC-1GE-SFP-CU wik card.
Moved the link to a built in port on the router and the issue resolved.
