About asldavid

asldavid · 06-09-2013

Hi all,I try to configure 3 routers trying to talk to each on ospf NBMA. As you can see, i have put the serial interface on Master on point-to-multipoint and the other 2 router serial interface on point-to-point. After changing the hello-interval on ...

asldavid · 11-16-2012

Hi,What should the duplex mode to be set on a routed port gi0/21 that are running HSRP ? I try setting the gi0/21 to full, but it caused the port to be down.The only way for the port to be up is setting it to half duplex. Please advise..Cisco 3750 Sw...

asldavid · 11-15-2012

Hi,What the different between using hsrp on vlan interface and on physical port (routed port) on Cisco 3750 Switch? Wha the benefits?Please advise.Regards,David

asldavid · 06-09-2013

Hi Rolf, You life saver... The issues is with the frame-relay mapping... Great.Master#sh ip ospf neighbor Neighbor ID Pri State Dead Time Address Interface3.3.3.3 1 FULL/ - 00:00:33 10.12.3.3 Ser...

asldavid · 06-09-2013

Hi Rolf,I have done clear ip ospf process on all router and also done reboot. But it still stuck on exstart state. I turn on the debug ip ospf events on master and i see the following.. Appreciate your advises..00:16:35: OSPF: Rcv DBD from 3.3.3.3 on...

asldavid · 11-15-2012

Hi Harish,Thank for the prompt reply./A vlan can contain number of physical ports.Assuming all the ports in the vlan are connecting to uplink, if we configure hsrp on that interface vlan, how does hsrp know when to failover ? when all the ports on t...

Member Since	‎09-19-2011 11:52 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	6

User Statistics

User Activity

OSPF NBMA question

Duplex mode on the HSRP routed port on Cisco 3750

Different using hsrp on vlan and physical port on Cisco 3750 switch

OSPF NBMA question

OSPF NBMA question

Different using hsrp on vlan and physical port on Cisco 3750 swi