About johncaston_2

johncaston_2 · 06-20-2017

We have an unusual situation whereby we are supplying LAN as a managed service but will allow clients to control port security via 802.1X Although I can get this working fine, we're concerned that there's nothing stopping the client changing the por...

johncaston_2 · 09-16-2015

Hi All, I have a client replacing their existing WiFi with a Cisco solution. They currently have a guest SSID with a PSK and have an external proxy presenting an AUP disclaimer page that they have to accept before proceeding - they initially want to ...

johncaston_2 · 03-24-2015

Hi All,I'm in the process of designing a network solution for a client and sales have proposed the ASA 5506-X firewall. I have a requirement for a DMZ zone. I recall that the 5505 only supported inside and outside interfaces. can anyone confirm that ...

johncaston_2 · 06-02-2013

Hi All,I've just started a project to provide a total wireless solution for a local hospital and I'm intending to do a wireless survey next week to validate the NCS planning tool and do get a better understanding of the environment. This particular h...

johncaston_2 · 04-29-2013

I have a site with a large number of AP's and two WLC. I need to do some maintenance on the primary WLC so need to move all the AP's to the secondary controller and I'd like to do this gracefully, without impacting the site very much.I've manually ch...

johncaston_2 · 06-22-2017

Thanks Marvin, That's what it looks like to me too, so I'm just going to have to remove CoA and say "basic auth only Thanks for your feedback Cheers, john

johncaston_2 · 09-22-2015

Hi Shahin, I think the problem is the "Default - Internal Users" in your Authentication rule, it's likely hitting that after you've already successfully been authenticated and then it will fail.Attached is my rule - if the condition is met, the defau...

johncaston_2 · 03-26-2015

OK thanks Vibhor, I'll give it a go and see what happens many thanks,John

johncaston_2 · 03-25-2015

Thanks Vibhor, I've been searching through those data sheets and guides all afternoon but couldn't find anything specifically stating if it had 2, 3 or more configurable interfaces; you would think it would support a 3rd zone but then it is the botto...

johncaston_2 · 02-26-2015

Hi Terry, Just wondering if you got an answer to your problem?I am deploying a new solution with ISE 1.3 and I was having a similar problem with my wireless users when I tried to enable it last nightCheers,John

Member Since	‎07-28-2005 01:54 PM
Date Last Visited	‎10-09-2017 01:47 PM
Posts	110
Total Helpful Votes Received	32

User Statistics

User Activity

Wired 802.1X and restricting VLAN assignment

Presenting a disclaimer page for PSK WLAN

DMZ interface on ASA 5506-X

Hospital Wireless Site Survey (pre-install)

Gracefully moving AP's between WLC

Thanks Marvin,

Hi Shahin, I think the

OK thanks Vibhor, I'll give

Thanks Vibhor, I've been

Hi Terry, Just wondering if