Hello allI'm looking to update our documentation on MDS9000 switch recovery - specifically replacing the whole switch after an swapout.The MDS cookbook has a procedure for replacing one but makes no mention of what to do differently if the switch is ...

Hello allI'd appreciate feedback on wether this is looked upon as good practice or not.For all the Cisco SAN implementations I have done to date, I have always trunked VSAN1 (but obviously NOT used it for customer data).  I do this for a couple of re...

Hello AllI'm currently replacing an existing Brocade SAN with a 9134 based one (not a big site).Now the 9134 is also available in a stacked config (buying through IBM)  which consists:1 x 91342 x 10Gb port activation Licenses2 x 10Gb CX4 copper trans...