About valsidalv

valsidalv · 09-28-2012

Hi,I'm configuring environment according to attached picture. In this infrastrucure will be blade servers with teaming NFT, so only one network card will be up.Could you please advice me the best spanning tree design for this infratructure?Thank you ...

valsidalv · 08-22-2012

Hi,I have 2 Cisco Pix 515E. Both are on the same subnets.Cisco1 has internal IP 10.0.0.1 and Cisco2 10.0.0.2. Internal servers have default gateway on Cisco1.When I establish VPN to Cisco2, connect to internal servers doesn't work due to routing.When...

valsidalv · 03-17-2009

Hi,I have Cisco Pix 515E,7.2(1) with two networks - inside and dmz. Communication between these network is NATed. In inside is Windows domain called GRP. In dmz I have some workstations which need to be domain member of GRP. Is it any possibility to ...

valsidalv · 02-06-2009

Hi,I have Cisco PIX 515E(8.0.3) and Cisco 5520(8.0.4). Between these devices I made L2L VPN.Behind Pix1 is LAN 192.168.10.0/24Behind Pix2 is LAN 10.11.13.0/24Do I need outside interface ACL's to communicate these LAN's?Or it's enough to configure cry...

valsidalv · 01-27-2009

Hi,I have 2 Cisco Pix(Pix1, Pix2) 515E(8.0.4). Between these devices exist L2L VPN, which are configured on outside interfaces. On Pix2 I configured remote access VPN on outside interace, too.Is it possible to reach LAN behind Pix1, by using remote a...

valsidalv · 03-20-2009

Thanks, very helpful document. There is one very important information for me:NoteActive Directory functionality is not supported over a router that has Network Address Translation (NAT) enabled. The configuration recommendations in this paper apply ...

valsidalv · 03-17-2009

Thanks.I know this document, but it is about accessing VPN users. There is nothing about my question.Vladislav

valsidalv · 03-17-2009

Thanks.I have no problem to define ACL. The main question was about windows domain. I don't know if active directory requires anything special to allow on pix.Or it is enough to allow standard windows ports - 138, 139, 445?Vladislav

valsidalv · 02-06-2009

So, if I have "sysopt connection permit-vpn" enabled, access control inside L2L VPN is only done with crypto map access list?Because this doesn't work for me. I must allow communication from 10.11.13.0/24 to 192.168.10.0/24 in interface ACL(I can see...

valsidalv · 01-29-2009

Thanks, it looks good.I have some subquestion.1. Could you please explain me this statement?nat (oustide) 1 140.40.30.0 255.255.255.0 ( PAT for RA vpn for internet access if u r doing full tunnel)It is therefore, I need to translate RA pool to 172.27...

Member Since	‎09-25-2007 11:27 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	28

User Statistics

User Activity

Blade switch STP advice

Routing between VPN

AD through Cisco Pix

L2L VPN question

L2L VPN and remote access VPN

Re: AD through Cisco Pix

Re: AD through Cisco Pix

Re: AD through Cisco Pix

Re: L2L VPN question

Re: L2L VPN and remote access VPN