Hello,I have an asr 9001 chassis with a module A9K-MPA-8X10GE but its status is not allow online 0/0/0 A9K-MPA-8X10GE NOT ALLOW ONLIN PWR,NSHUT,MON Does it need a license to activate or is not supported? Thank you,
Hi, I have a case where I need to establish a CFM session between a downward MEP and upward MEP. Is this possible? Or CFM session is always between either two downward MEPs or two upward MEPs. Any reply is much appreciated. Thanks
Hello All,ON switch 6500 i have configured an interface vlan x and applied policies on inboud and outbound directions as per below:interface Vlanx ip address 1.1.1.1 255.255.255.0 service-policy input VlaX-in service-policy output VlaX-out Policy Ma...
Hello We have configured a Router cisco 7206VXR (NPE-G1) as PPPoE Server and a AAA server remote. We want to send the attribute 31 Calling-Station-ID (MaC address client) to the radius, but is not possible.In router i have configured : radius-server...
Hi Everybody,im havin a problem with NAT at cisco router 7206VXR (NPE-G1) processor, Software (C7200-ADVENTERPRISEK9_SNA-M), Version 12.4(6)T11The configuration is as below:ip nat inside source list 2688 pool Office overloadACL 268810 deny ip 192.16...
From the version show command I see it is asr9001 chassis, not asr9001-S. Does it make any difference? RP/0/RSP0/CPU0:asr9k#show versionFri Mar 1 13:13:49.945 ESTCisco IOS XR Software, Version 5.3.4[Default]Copyright (c) 2016 by Cisco Systems, Inc.RO...
Thank you for the article, that is so informative and helpful. We have an ASR9001E (P40X0 PPC) stuck on Rommon. I tried to turboboot it using TFTP and USB. But seems that it loads the VM( asr9k-mini-px.vm-5.3.3) and works until some point and then it...