Dear friends, I have a wireless sytem with a WLC 4400 and several 1522 Access Points. They don't actually function as Access Points because I'm using radio communication only for backhaul. There are no clients connected to the Access Points. All traffic on the network comes from the devices connected on the LANs that are bridged through the APs ethernet port. I would like to create filters to allow only certain devices to be able to transmit over the radio link. I've used this in the past on 1310 units and it was very easy to do via GUI. This filter could be either by IP or MAC Addresses. IP would be better for me. I've looked for this on all related documentation, but found nothing. Is this possible to be done with these models? How? Any help is appreciated. Thank you.
... View more
Dear friends, I've had some problems in my wireless system consisting of a WLC 4400 and 2 1522 APs connected in a pont-two-point way. To investigate the causes of the issue, I took a look at Trap Logs under MONITOR tab. But, I can only see a limited number of traps. The number of traps since last reset is about 5400, but the list displays about 250. Are the older event logs lost? If not, how I can get them? I've also tried to updload the files, but the same list came up. How many events are stored? Thanks in advance.
... View more