Hello Experts,
We have a pair of 4110 FTD containers configured for Active/Standby HA terminating VPN sessions. In our FMC 6.4 under Overview> Dashboards> Access Controlled User Statistics, the "Active VPN Sessions by Device" widget is showing active...
Hello Experts,
I have a customer that would like a L2 VPN pseudowire between his two sites. He also states that jumbo frames are a requirement as well and I expect to receive jumbo frames from the customer attachment circuit. However, all of my MPLS...
Hello experts,
I have a situation where my customer is hosting multiple tenants by means of virtual contexts. We recently upgraded our Prime Infrastructure to version 3.1 to enable us to apply alarm policies to filter down on both the number and type...
Hello experts,
I have a Cisco Prime Infrastructure 3.0 system that I am setting up email notifications for alarms that get registered. It appears the email notifications for alarms can only be set for both alarm severity level and the "Category" in w...
[OK] Site to Site IPSec + GRE = success, no problems.[OK] IPSec remote access = success, no problems.[NO] SSLVPN = remote users can successfully connect to all internal systems. Cannot pass traffic to the Internet.Hardware:Cisco 2811, Cis...
Hello Giuseppe,
I need some additional clarification please. I suspect I am in the same boat as Syjeon (original post) whereby I have a customer that would like a L2 VPN pseudowire between his two sites. He also states that jumbo frames are a requi...
<snippet> "I have not come up with a positive reason that I need it"
In the past I have needed access to install VMWare Tools in the virtual machine. I have searched the Prime Infrastructure 3.1 documentation and see no references to installing VMWar...
Michal,
Thank you much for your reply. As suspected, traffic coming across the SSLVPN was not being processed bypassing the NAT (via PBR) hairpinning function. Your recommendation on deployingvirtual templates got me digging in the right direction. E...
