We are running Cisco Prime Infrastructure 3.0 . We are wanting email notifications for Switches and Hubs when one goes down and up within a minute. We have selected the option Switches and Hubs with severity level as Critical under the Email Notifica...
Is their a way to block a device from accessing one SSID and allowing access to another SSID? This is a controller base wireless network. I would like to allow access of a certain device to the corporate network and deny access to the public network....
Is there a function within Cisco Prime Infrastructure 2.0 (2.0.0.0.294) that will display the last time that an interface was active? Our end switch hardware is as follows C2960s-48fps and C3750-48PS-S. See below for command and command output from t...
Can someone explain to me if this cable is good or bad?Interface Speed Local pair Pair length Remote pair Pair status--------- ----- ---------- ------------------ ----------- --------------------Gi1/0/41 100M Pair A 60 +/- 0 meters N/...
Is there a wireless LAN software that I can use with my laptop to find what the dns name of the access point that I am connected to? I am not looking for the SSID name.Thanks,techbjs08
Adam,Try the following commands. This will give you the last up information. Someone else in the community shared this with me quite awhile back. It has helped us a lot.For a single interface.Cisco-Switch#show int g1/0/7 Last input never, output 1y2...
Hey p-allen,Try this and see if it works for you.Getting the IP Address of devices connected to a Layer 2 switch (C2960 & C3750).conf tip device tracking interface range g1/0/1 - 48ip device tracking max 10end---- Wait for approximately 10 seconds -...