Hello, Recently we have upgraded our 2960-x switches to IOS version 15.0(2) EX5 (universal-K9),Since the upgrade we are unable to get the power consumption status of the switch from the SNMP monitoring system, Sadly the SNMP navigator does not have t...
Hello,We have an issue involving DCNM 6, For some reason the Java Client gets disconnected every couple of minutesWhile the Java Client keep disconnecting we have constant access to the web client,Each disconnection requires re-opening the client in ...
Hi all,I think I ran into a bug running BGP on IOS-XE, I have an ASR1001 running two BGP peers witch recieving full CIDR (around 500,000 routes).when both peers reach established state and start sending\recieving the routes the memory of the router ...
Hello,As a matter of fact we did manage to solve the JAVA disconnections by performing a clean install of the DCNM, our customer has tried to migrate the server to a virtual environment and the service just stopped responding no matter what we did so...
Hello Dmytro,Sorry for the delay in my response, The router is not connected to the network and as a resault the BGP peers are down,At this state there is no issue so I can't provide you with the relevant information.I can see CSCsw63003 status is re...
Hello Clark, Not sure if this will help but i have encountered a similar issue which was solved by performing the NAT via a route-mapPlease try the following configuration :Route-map NAT match-any permit 10 match ip address 100 match interface Dialer...
