what command can allows me to measure the rate of traffic on an interface. The reason I am asking is that I see TX Discards and that is usually indicate more data being transmitted than can be buffered by the interface. I heard that I can use traffic...
form site A I am unable to ping a loopback of site B but I am able to ping the internal interface of site B. using BGP b/w the 2 sites ROUTER A ----- > Ping Router B loopback failedROUTER A ----- > Ping Router B internal interface success Thank ...
Hello and thank you for reading my post. I have 2081 voip router. I would like to upgrade the IOS to support higher ver of CME. this is for a lab learning environment , I realize that I have only 64 of Ram , I am purchasing "MEM2801-256D= 2...
I am starting to build a basic voice lab for voice exams and training and I need some expert opinion pls..My first question is what is the latest CME that I can install on 2801 ? my second question is hardware related.I have 3550 POE and 2 cis...
Hi all , I have this question that confused me little .. What is the name of the technology that allows two or more Layer 2 networks to travel on the same physical wire ? my answer will be Vlan because it is using do1q. but am i be wrong....
Thank you very much for you time Joseph, greatly appreciated, as you can tell I am newbie with Wan links and still have a couple of questionsI would like further decrease drops.what command should I use if my IOS version support queue-length?.what w...
Hi Joseph Here is what I have one of my router.show runpolicy-map SHAPING-policy class class-default shape average 44000000 fair-queue------------------------------------------------------------------------RTR1#show policy-map int s1/0 Serial1/0 S...
I think I found this "Configuring Class-Based Shaping" http://www.cisco.com/c/en/us/td/docs/ios/12_2/qos/configuration/guide/fqos_c/qcfcbshp.html#wp1004483Just need to confirm from the Network pro in this forum if that is what I need , any one with k...
Very informative Hassan, I am still looking for a policy command that can help configure traffic shaping and from that policy I should be able to tell how much traffic was above my 44 mg
Thanks Reza, I agree with the answer, in My case I have a DS3 circuit from my router to the isp . I see Tx Discards time to time , I would like to implement some traffic shaping to capture the burst of traffic that exceed DS3 bandwidth and do show po...