rwiechman
Level 1
Level 1
Member since ‎01-03-2010
‎08-18-2017

User Statistics

  • 15 Posts
  • 0 Solutions
  • 4 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote
5 Replies

User Activity

I built a new PI 2.1 (OVF) and imported the config from the running 1.3 instance. Everything is fine except that the tftp server refuses to work. It will not serve files, nor can I put file in it.  All of our WLC backups are failing. Using a tftp cli...
I have an inside network using PAT to one outside address. Our DNS server is on anotherlocal, but outside address.  I can't get the inside network to successfully get addresses.I have another inside address that just uses the wirewall and gets addres...
ASA is 5540 w/8.3. I have a large inside block of inside address I want to NAT or PATto outside addresses.  Is it possible to use a block of outside addresses with NAT withrollover PAT to the whole range, or is it restricted to roll over to only a si...
I have a current ASA (5540, 8.3(2)) that is running in routedmode, doing a VPN endpoint as well as a wirewall for anotherinside network.  They use the single public IP addressthat is on the outside interface, which carries thedefault route.I want to ...
I have a routed firewall configuration that requires folks on Inside network to be able to useIPsec VPN which terminates both at the shared public interface and also other end points.I can't seem to set the ASA to allow it.  I've added a low security...
Community Statistics
Member Since ‎01-03-2010 08:19 AM
Date Last Visited ‎08-18-2017 04:01 AM
Posts 15
Total Helpful Votes Received 5
Helpful Votes From
Helpful Votes Given To