Hello Everyone,
I have a short question in regards to softkey templates and features for IP Phones.
When having a single call connected the softkeys given are as needed and there are no issues to forward a call. However the issue is, when a second ...
Dear all,
I am currently setting up a CUBE (ISR 4321) in order to connect to the ISP's SIP Trunk. I can establish connections to the outside world, but seemingly can't get it to work routing calls to the internal phones.
I'd be happy about any advi...
Hello everyone,
I've got following issue:
In short: Searching for an entry in the directory resolves to only one entry being shown in the jabber client.
We've got a setup of a two CUCM-Cluster in Version 11.5.1 and we are trying to utilize the new ...
Hello Everyone, I've freshly installed a CUP Server (Version 8.6) and followed the guides to setup the Trunk to CUCM and activate the needed services.When I'm now trying to connect to the CUP Server via Jabber 9.7 for Windows Client using the IP-Adre...
Hello everyone, I am currently searching for the IM & Presence 8.6.5 Bootable iso, which I cant seem to find in the Downloads here on Cisco.com.Is it not available online anymore?Looking forward to clearing this up. Regards
Hi Mohammed,
Sorry if I wasn't clear enough.
It is a CUCM 11.5 Deployment.
When a call is connected the softkeys for this connected call are hold, transfer and EndCall for example. When another call comes in on the same line the softkeys change and...
Thank you so much for the last reply. Toll Fraud prevention it was. Checking the trusted Networks and addresses showed that there was a typo in there, which did prevent the call routing. Thanks a lot and have a great day,
Chris
Sorry for the wrong info, was a typo.
All I get is Invite messages for quite some time and at some point the call disconnects, I do not see any message regarding this on the voice gateway.
Well, I Want to forward the complete number (i.e. 0049302...
Hello Rajan,
Thanks for helping out.
I fail to see how this is going to match Dial Peer 11 instead of Dial Peer 10.
Debug voip ccapi inout is not coming up with anything for the failed call (also - there is no signaling heard on the calling phone...
