About sapper12b

sapper12b · 10-09-2017

The AP was paired with the wrong conroller and now I am unable to pair it with the correct controller. I have went through the process of holding in the Mode button while connecting it to power but it appears to still be looking for the other control...

sapper12b · 06-12-2013

I recently changed jobs and at the new location we are primarily running Catalyst 2960G series switches with the exception of one 3750. All of the switches are setup in a cluster with the 3750 being the cluster master. My question is what is the bene...

sapper12b · 08-06-2012

We recently upgraded our bandwidth and I have to change the ip address on our ASA 5510. I just want to make sure that I am doing it right. All I will need to do is open up the ASDM and under confiugration go to interfaces and make the needed changes ...

sapper12b · 12-04-2006

What would be the best way to find out if CISCO hardware that you have purchased was fake?

sapper12b · 10-16-2017

@divp wrote: Hi, Please run the below commands on the AP console: debug capwap console cli test capwap erase And then check whether the AP joins to the right Controller. Ensure that the DHCP option 43 or DNS provides the correct WLC mgmt IP. ...

sapper12b · 10-09-2017

Unfortunetly I do not have access to the controller to do that. And the one person who does is out for a while.

sapper12b · 08-06-2012

Yes, I plan on needing to make changes to both may ACL and my NAT settings.

Member Since	‎12-04-2006 02:44 PM
Date Last Visited	‎11-13-2017 05:48 PM
Posts	21

User Statistics

User Activity

3702i factory reset

Switch Clustering benefits

Reconfigure ASA outside interface

Faked CISCO hardware

Re: 3702i factory reset

Re: 3702i factory reset

Reconfigure ASA outside interface