Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everbody, is it possbile to configure QoS System Class Settings for a UCS Domain through Central? I know how to create a QoS System Class Policy for a domain Group within central but I cannot find out how to apply it. If I just create the Polic...
Hi,
one of my SIP-Providers uses the country code for the incomming caller id formated "+49 xxxx xxxxx". On the Display of the SPA-302D it is shown as 49 xxxx xxxxx. This does several issues to me. The CID isn't mapped to a known contact, which is ...
Hello,I’m running a Cisco 3845 with a AIM-VPN/SSL-3 Module. My WAN Interface (a DSL Connection) is configured with NAT overload. This is also the interface where the sslvpn connection is terminating. If a user connects from the internet to the SSLVPN...
Hi Ron,
check the configured DHCP lease for the blade server. Are Default Gateway and PXE Server configured correctly? The ARP timeout indicates there is an IP- Address not reachable. I assume it's the default gateway and the PXE Server is located ...
Since Vlan 1 is automatically assign on all Uplinks it is not usable for productive traffic in a disjoint Layer 2 configuration. The DR election is random and there is no preemption in case of a link failure.
Hello Wes, thank you for the detailed description. I'll will try this by the end of the week. At the moment I don't have any UCS Domain running firmware 3.1.3 available. Kind regards Lukasz
