Good afternoon Net pros.I have a CCME system setup with a sip-ua trunk and incoming / outgoing calls work fine.However, if I let the phone ring, and dont answer the the call, it gets dropped after roughly 10 seconds. There are no call-forward busy/no...
Good afternoon, I have a cisco 2851 running IOS Version 12.4(11)T2 with CME 4.0(2).I will be running a cisco 877w on the remote site.What I am wondering is what are the best techniques to set this up?Should I use a Remote access or a Site to Site typ...
I have a problem where a wrong dialpeer is getting matched to a number I am trying to dial and making the call fail.I am trying to dial a number "9141123456"9 is to "dial out"141 is a prefix to make the call appear from "unknown"123456 is the number ...
CIPC when on our local network will register fine, but when I take the laptop home and connect via VPN CIPC is stuck at "Registering"I can establish the VPN and have tested connectivity to my CCME system via ping.Here is "debug tftp events" when CIPC...
Hi there.. I have a CCME system with an external product from Stonevoice doing call queueing. I am looking to make the queue music a reassuring tone.What I am looking for is a sound file for tone on hold. Similar to that of when there's no music on h...
Give it a test with the following handy command GJ-CME-01#test voice translation-rule 5 01891613513 The output after that should show you the original number and the translated number.
I've used Callrex from Telrex - http://www.telrex.com/products/call-recording.php with Call Manager Express before and it's worked great. I realised you asked for CUCM but it does support that. It works via port/vlan mirroring at the switch level.Onc...
voice translation-profile Inbound
translate calling 5 <--- This is applied to the calling number
translate called 2
voice translation-rule 5 <--- Which is this rule
rule 1 // /90/
It looks like that rule is replacing whatever the number is with...
Is the UC560 restarting as well?"show version" should show you the uptime.Also, as already mentioned it's good practice to upgrade the IOS & phone firmware if possible.
