You can not have more then 1 data vlan assigned to an access port except in the cae of a voice vlan ID and a data vlan ID. One you configure say port 1 as vlan 801 and port 2 as vlan 802 and switchport protected, all layer 2 protocol traffic will sto...
Sorry this was a little vague. Here are a few examples for EIGRP and BGP:EIGRP=====In the following example, EIGRP process 1 is configured to accept two networks, the default network 0.0.0.0 and network 10.108.0.0:access-list 1 permit 0.0.0.0access...
Here are a few ways to match the default route in order to filter or allow in routing updates.Using ip prefix-list (the preferred way)ip prefix-list MATCH_DEFAULT seq 5 permit 0.0.0.0/0using ACLs (least preferred method)standard ACLaccess-list 1 perm...
The Cisco 2800 router with WIC-2T will support only a maximum of 2Mbps. You will need to upgrade to the newer HWIC module in the 2800 router to go to 4Mbps or 8Mbps on each port.. What is the router and WIC on the DTE end of the link? How long is ...
Aloha Omal,I am not sure where the confusion is coming from. But if you look at all three routers you see the default summary route for network 1.0.0.0/8 under the "sh ip route" command. Also, you see the gateway of last resort has now been set.R1#...
