Hi I tried to join 2nd APIC to exist cluster, however it failed.execute " avread " on APIC1, it showsapic1# avreadCluster:-------------------------------------------------------------------------fabricDomainName ACI FabricdiscoveryMode PERMISSIVEcl...
Hi Experts,
I am confused about the relationship between shape burst size and queue-limit.
I check the configuration guide, there are 2 locations can set the buffer size, 1. shpae with Excess burst size 2. queue-limit
If there is a burst traffic goin...
Dear Experts,
I have a question about load-sharing in OSPF 。
There are two equal-cost routes in the routing tale, in my idea, the forwarding behavior should be load-sharing. however, the traffic is forwarding on one uplink.
Below is "show" info:
...
Hi Experts,
I have a question regarding to mac address learning on ASR9K.
Per the log below, I am curious that why the mac address is learned from different location? one is from LC, and another is from RSP.
RP/0/RSP1/CPU0:LAR712#sho l2vpn forward...
Hi
I have few questions about nVEdge cluster license.
1. Is it really necessary for building cluster?
2. When should I install the license? before build cluster or after that?
3. If I don't the NV lic, what will happen? only have error warning or ...
HiThanks for the reply, member info of Bundle-Ethernet 2601 & 2602 shown as below,RP/0/RSP0/CPU0:#show bundle bundle-ether 2601Fri May 18 10:18:30.357 GMTBundle-Ether2601 Status: Up Local links <active/standby/con...
Hi
I am using ASR9010(nVEdge Cluster) with IOSXR 5.3.3.
Because this Router has service traffic on it, I don,t have the authorization to change config. except show command.
thank you
